Oxygen flow control regulators are pressure reducing devices which lower oxygen pressure from a cylinder to levels which can be safely used by the user. Oxygen flow control regulators are intended for administration of oxygen to patients who need increased oxygen levels to improve their breathing conditions. In addition, some models may be used in emergency situations. In any emergency situation, be sure to contact a physician or EMS immediately.
Use
- Be sure the regulator is in the “off “position by rotating the knob counterclockwise to the “0” position
- For safety, be sure you are not directly in front of or behind the regulator when opening the cylinder valve
- SLOWLY tum the cylinder valve on (counter clockwise), about one full turn
- If you can hear a hissing sound, there is a leak in the system. Turn the cylinder off and turn the regulator on to relieve any built up pressure. Try tightening the regulator to the cylinder and opening the cylinder again. If this does not help, shut the system down again and contact a service representative. NEVER at- tempt to repair a regulator or cylinder yourself.
- Adjust the flow rate setting by turning the knob clockwise until the desired setting shows through the window. For emergency situations, this should be at least 6 LPM
- If the cylinder pressure falls below 300 PSI, you should exchange the cylinder for a full one
- To turn off the system, close the cylinder valve, wait for oxygen to flow out of the regulator, and turn regulator to the “0” position
- NEVER try to remove the regulator unless the cylinder is off and pressure has been relieved
